Repository navigation
support for ATSAMD21E18A controller #1044
Replies: 1 comment
|
Porting DAPLink to a new interface is quite a complex task. Potentially all files in Once we add support for the TinyUSB stack it should get much easier and we are more likely to document the process. |
Uh oh!
There was an error while loading. Please reload this page.
Hi ,
i am new to DAPLink porting. i would like to port DAP link for " ATSAMD21E18A" processor . i have seen support for Atmel controller "sam3u2c_bl" board . from the make file i have observed that the following source files required to build the application
......\source\board\sam3u2c_bl.c
......\source\daplink\HardFault_Handler.c
......\source\daplink\bootloader\daplink.c
......\source\daplink\bootloader\main_bootloader.c
......\source\daplink\circ_buf.c
......\source\daplink\cortex_m.c
......\source\daplink\crc32.c
......\source\daplink\daplink_debug.c
......\source\daplink\drag-n-drop\file_stream.c
......\source\daplink\drag-n-drop\flash_decoder.c
......\source\daplink\drag-n-drop\flash_intf.c
......\source\daplink\drag-n-drop\flash_manager.c
......\source\daplink\drag-n-drop\iap_flash_intf.c
......\source\daplink\drag-n-drop\intelhex.c
......\source\daplink\drag-n-drop\vfs_manager.c
......\source\daplink\drag-n-drop\vfs_user.c
......\source\daplink\drag-n-drop\virtual_fs.c
......\source\daplink\error.c
......\source\daplink\flash_hal.c
......\source\daplink\info.c
......\source\daplink\sdk_stub.c
......\source\daplink\settings\settings.c
......\source\daplink\settings\settings_rom_stub.c
......\source\daplink\util.c
......\source\daplink\validation.c
......\source\hic_hal\atmel\sam3u2c\flash_hal_SAM3U.c
......\source\hic_hal\atmel\sam3u2c\gpio.c
......\source\hic_hal\atmel\sam3u2c\read_uid.c
......\source\hic_hal\atmel\sam3u2c\system_SAM3U.c
......\source\hic_hal\atmel\sam3u2c\uart.c
......\source\hic_hal\atmel\sam3u2c\usb_config.c
......\source\hic_hal\atmel\sam3u2c\usbd_ATSAM3U2C.c
......\source\rtos_none\SysTick_Handler.c
......\source\rtos_none\cmsis_os2_port.c
......\source\target\target_board.c
......\source\target\target_default.c
......\source\usb\msc\usbd_core_msc.c
......\source\usb\msc\usbd_msc.c
......\source\usb\usbd_core.c
i would like to check that the following HAL files need to be rewrite for ATSAMD21E18A"?
can someone provide some information related to required steps for porting?
Regards,
Raju
All reactions