[FEAT]: Add CLI Setup Instructions with Example for Setting Folder Path

[kartik-212004]

Share your suggestion

Currently, the Full CLI Setup can be a bit confusing for beginners—especially when it comes to setting the folder path. This is one of the trickiest steps because there are no clear instructions on how to do it properly.

Problem:

• No clear step-by-step instruction on how to provide or set the folder path.

• Beginners might not know whether to use absolute or relative paths.

• This can cause misconfigurations or failed setups.

Validations

• I have checked other issues to see if my issue was already discussed or addressed

[DavidHDev]

I don't think it's confusing at all, it's as clear as it gets. The CLI instructions once you run the commands are controlled by JSREPO, and I believe they're very clear, but if you want a change in the wording you can open an issue there instead.

[kartik-212004]

I don't think it's confusing at all, it's as clear as it gets. The CLI instructions once you run the commands are controlled by JSREPO, and I believe they're very clear, but if you want a change in the wording you can open an issue there instead.

I understand your point, if the CLI instructions are managed by JSREPO and the wording is clear there, then maybe this issue isn’t needed here directly. My suggestion was mainly from a beginner’s perspective, as I personally found the folder path part a bit tricky without a specific example.