Is there a way to set CAN silent mode?

[parthmpatel1110]

Hi,

I am making a CAN logger. The basic requirement is that the logger should not provide an ACK after the EOD of the frame. Is it possible?

[KevinOConnor]

The software does not directly support a "silent" mode. However, if you have an extra unused pin on the micro-controller, there is a good chance you could configure the gpio_tx parameter to that unused pin. That is, I think the software may be able to read canbus packets on the gpio_rx pin even if there isn't a valid tx connection.

Cheers,
-Kevin

[parthmpatel1110]

Yes, I thought so. Thanks, I will try.

[KevinOConnor]

FYI, I created PR #82 .

-Kevin