Cura configure only opens when I initially open the program.

[Randeb74]

Cura Version

5.9.0

Operating System

Mac OS Sequoia

Printer

Prusa i3

Reproduction steps

I can only access the Cura configuration settings on a fresh opening of the program. After I load a file I have to close the program and reopen to access the config settings. Not a big deal but a bit annoying when you're trying to get a new printer setup working right. Thanks.

Actual results

First comments says it all.

Expected results

First comment says it all.

Add your .zip and screenshots here ⬇️

Nothing to add.

[GregValiant]

Thanks for the report.
That doesn't happen on my Win10 system and there have not been other reports of this behavior. It might be system-specific.

• Open Cura and recreate the condition.
• Use the "Help | Export package for technical support" command then zip that file and post it here (not via email).

Maybe the log file will give a clue as to what is going on.

[Randeb74]

Compress.zip

Hi Greg, here is the file that you requested. Thank you for taking a look at this issue.

[GregValiant]

The Cura team is busy getting ready for a new release so it may be a while before they get to this.
I don't see anything obvious in the log file so you will need them to take a look.

[Randeb74]

Thank you, that’s fine with me. Great service snd a great free program regardless! RandyOn Jan 28, 2025, at 12:04 PM, GregValiant ***@***.***> wrote: The Cura team is busy getting ready for a new release so it may be a while before they get to this. I don't see anything obvious in the log file so you will need them to take a look. —Reply to this email directly, view it on GitHub, or unsubscribe.You are receiving this because you authored the thread.Message ID: ***@***.***>