Correct settings for rssi Steele pdb

[Carmaniac626]

Hi there.
I've been following the few videos online and tutorials of how to setup the rssi to show up in my osd and so far I've gotten it to show up but I get 0-1db. Does that mean that perhaps my scale in the config tool isn't set correctly ? I have it currently set to 1009-2000 and the mixer on my taranis is weight 100 scale 0.

Tanks in advance

[awolf78]

Did you double check the RSSI section here:
https://github.com/awolf78/KISS_OSD/wiki#setup-of-kiss-osd

[Carmaniac626]

Hi there, yes I did review it. If i mess around with the weight and offset in the mixer page of my radio i can see receiving signal but goes int negative and it doesnt make any sense. https://newbeedrone.com/products/frsky-2-4ghz-xsr Here is a link to the receiver I am using currently. In the forum they mention to flash the firmware if the xm+ is being used. I didnt find that necessary since im using a different receiver but maybe that is the case. Could you confirm if that would be something for me to try or not ? I dont want to try and flash my receiver and get it damaged. I played around with the setting of the kiss osd and that didnt change anything. The FC sees the input and reads it as a value between 1000-2000 ppm but I dont know where is the missing link. My radio sees the rssi. The Flight controller does as well, however the osd can see it in negative value if I do weight 200 and offset -100 but the numbers dont make any sense. Best regards, Rumen

…

On Sat, Dec 8, 2018 at 4:49 AM awolf78 ***@***.***> wrote: Did you double check the RSSI section here: https://github.com/awolf78/KISS_OSD/wiki#setup-of-kiss-osd — You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub <#58 (comment)>, or mute the thread <https://github.com/notifications/unsubscribe-auth/Arl6TdDwTUltiNSCuFP4gP4R2Iccs1HOks5u27VBgaJpZM4ZJjlz> .

[awolf78]

Can you post a DVR or video of what is happening?

[Carmaniac626]

Yes I will try to do it today or tomorrow. Thanks for the prompt response. - Rumen

…

On Sun, Dec 9, 2018 at 3:03 PM awolf78 ***@***.***> wrote: Can you post a DVR or video of what is happening? — You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub <#58 (comment)>, or mute the thread <https://github.com/notifications/unsubscribe-auth/Arl6TcIpeR8C4GHzqghkobp0ZJbRXbhMks5u3Za4gaJpZM4ZJjlz> .

[TheRcCrawlerKing]

Is the Mr. Steele PDB capable of receiving RSSI data from a Spektrum 4649t receiver?

[awolf78]

The Steele PDB receives its RSSI information through an AUX channel from the KISS FC. I have seen this for BF, but I don't think the KISS FC firmware is capable of forwarding the RSSI information.