micropython_help.txt

Executing main.py
Micro Python v1.2-59-gecb5792 on 2014-08-11; Teensy-3.1 with MK20DX256
Type "help()" for more information.
>>> 
>>> help()
Welcome to Micro Python!

For online help please visit http://micropython.org/help/.

Quick overview of commands for the board:
  pyb.info()    -- print some general information
  pyb.gc()      -- run the garbage collector
  pyb.delay(n)  -- wait for n milliseconds
  pyb.Switch()  -- create a switch object
                   Switch methods: (), callback(f)
  pyb.LED(n)    -- create an LED object for LED n (n=1,2,3,4)
                   LED methods: on(), off(), toggle(), intensity(<n>)
  pyb.Pin(pin)  -- get a pin, eg pyb.Pin('X1')
  pyb.Pin(pin, m, [p]) -- get a pin and configure it for IO mode m, pull mode p
                   Pin methods: init(..), value([v]), high(), low()
  pyb.ExtInt(pin, m, p, callback) -- create an external interrupt object
  pyb.ADC(pin)  -- make an analog object from a pin
                   ADC methods: read(), read_timed(buf, freq)
  pyb.DAC(port) -- make a DAC object
                   DAC methods: triangle(freq), write(n), write_timed(buf, freq)
  pyb.RTC()     -- make an RTC object; methods: datetime([val])
  pyb.rng()     -- get a 30-bit hardware random number
  pyb.Servo(n)  -- create Servo object for servo n (n=1,2,3,4)
                   Servo methods: calibration(..), angle([x, [t]]), speed([x, [t]])
  pyb.Accel()   -- create an Accelerometer object
                   Accelerometer methods: x(), y(), z(), tilt(), filtered_xyz()

Pins are numbered X1-X12, X17-X22, Y1-Y12, or by their MCU name
Pin IO modes are: pyb.Pin.IN, pyb.Pin.OUT_PP, pyb.Pin.OUT_OD
Pin pull modes are: pyb.Pin.PULL_NONE, pyb.Pin.PULL_UP, pyb.Pin.PULL_DOWN
Additional serial bus objects: pyb.I2C(n), pyb.SPI(n), pyb.UART(n)

Control commands:
  CTRL-A        -- on a blank line, enter raw REPL mode
  CTRL-B        -- on a blank line, enter normal REPL mode
  CTRL-C        -- interrupt a running program
  CTRL-D        -- on a blank line, do a soft reset of the board

For further help on a specific object, type help(obj)
>>> 
 CTRL-A Z for help |115200 8N1 | NOR | Minicom 2.6.1  | VT102 |      Offline