Skip to content

Latest commit

 

History

History
54 lines (42 loc) · 4.6 KB

README.md

File metadata and controls

54 lines (42 loc) · 4.6 KB

GPIB-USBCDC

GPIB-USBCDC is an interface bridge between GPIB (HPIB) and USB communication device class. It is Prologix GPIB-USB adapter clone with EFM8 Universal Bee or C8051F38x microcontroller.

Quick user guide

  1. Connect GPIB-USBCDC to the PC. GPIB-USBCDC is recognized as serial port, which will be installed with CDC inf file.
  2. Other usage is almost same as Prologix GPIB-USB adapter. Please see that product manual.

Manual

Nice user manual written by Alessandro Soraruf is available, Thanks! In addition, please set up your device with its address except for zero, in case of bus confliction reported by biergaizi.

Board

EagleCAD files are available (ver.1 schematics and layout. Its components are listed in BOM. The board design is published under Creative Commons Attribution-ShareAlike 4.0 International.

BOM (bill of material)

Part Value Package Multiple
C1, C4 1u / 6V3 1005 2
C2, C3, C5, C6 0.1u / 10V 1005 4
CON1 HRS ZX62R-B-5P 1
CON2 Norcomp 111-024-113L001 1
CON3 JST ZH B4B-ZR 1
IC1 EFM8UB20F32G-A-QFN32 or C8051F387-GM QFN32 1
IC2 SN75160BDWR or SN75ALS160DWR SO20 1
IC3 SN75162BDWR or SN75ALS162DWR SO24 1
LED1 Red 1608 1
LED2 Orange 1608 1
LED3 Green 1608 1
LED4 Blue 1608 1
R1, R2, R3, R4 470 1005 4
R5 1K 1005 1

Firmware

The official binary is published in github release. To build the firmware by yourself, install sdcc (testing with ver 3.3.0 #8604), and just "make" at "firmware" directory of the downloaded code. The generated firmware name is gpib-usbcdc.hex. The firmware code is published under New BSD License.

Build Status

How to write firmware to hardware

Connect a GPIB-USBCDC board and a PC via USB debug adapter (UDA) or compatible one. The minimum required programming connections are summarized in the following table. Then, use Flash Programming Utilities. Note: the board may not be recognized by a PC when an UDA is connected via USB hubs. UDA is recommended to connect a PC directly.

Signal UDA side GPIB-USBCDC board side
C2D 4th pin CON3 3rd pin
C2CK 7th pin CON3 4th pin
GND 3rd pin CON3 1st pin

Additional information