I am using a tap example of this library. It successfully detects the tap however the INT 1 pin of ADXL345 always remains HIGH even it detects the tap. It should change its state when there is a tap is detected Right? In my case its not happening. Correct me if I am doing something wrong.
Hardware:
ESP8266 (Node Mcu) adxl345 DMM is hooked up with INT1 to detect change in it voltage level.
I am using a tap example of this library. It successfully detects the tap however the INT 1 pin of ADXL345 always remains HIGH even it detects the tap. It should change its state when there is a tap is detected Right? In my case its not happening. Correct me if I am doing something wrong.
Hardware:
ESP8266 (Node Mcu) adxl345 DMM is hooked up with INT1 to detect change in it voltage level.