Hello Pina,
at first thank you very much for AeVOC. Works great and had a lot of fun building it.
However I have to admit I used a 3D Model for FDM printing as a housing.
Now to the topic.
At first I got no reading from the CCS811 and I was wondering if this has something to do with the Burn In mentioned by you and the Datasheet (https://cdn.sparkfun.com/assets/learn_tutorials/1/4/3/CCS811_Datasheet-DS000459.pdf) from sparkfun.
I found a specific page (https://wiki.keyestudio.com/KS0457_keyestudio_CCS811_Carbon_Dioxide_Air_Quality_Sensor) for my sensor pcb and it seems like the WAKE pin needs GND in order for CCS811 to work. At least now I get measurements.
Now I'm wondering if this is necessarily just for my CCS811 or for all of them?
Best wishes,
Sebastian
Hello Pina,
at first thank you very much for AeVOC. Works great and had a lot of fun building it.
However I have to admit I used a 3D Model for FDM printing as a housing.
Now to the topic.
At first I got no reading from the CCS811 and I was wondering if this has something to do with the Burn In mentioned by you and the Datasheet (https://cdn.sparkfun.com/assets/learn_tutorials/1/4/3/CCS811_Datasheet-DS000459.pdf) from sparkfun.
I found a specific page (https://wiki.keyestudio.com/KS0457_keyestudio_CCS811_Carbon_Dioxide_Air_Quality_Sensor) for my sensor pcb and it seems like the WAKE pin needs GND in order for CCS811 to work. At least now I get measurements.
Now I'm wondering if this is necessarily just for my CCS811 or for all of them?
Best wishes,
Sebastian