Nucleo-U385RG-Q is not resetting properly at 1.8V #2733
-
Please, before reporting any issue
Any questions/feedback/suggestions should be discussed on the stm32duino forum:
⚠ When reporting any issue, please try to provide all relevant information to help on its resolution. Describe the bug Arduino IDE debug message if using 3.3V: Arduino IDE debug message if using 1.8V: To Reproduce Expected behavior Desktop (please complete the following information):
Board (please complete the following information): Additional context |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment 4 replies
-
Hi @alexceltare2 |
Beta Was this translation helpful? Give feedback.
Fine. Thanks for the feedback. Anyway, I will ask internally if this issue is known.