Toolitems Images Cutoff on dragging to the vertical toolbar

[amartya4256]

Toolitems: cut off in horizontal placement if dragged from horizontal to vertical and dragged out without dropping and then put it back in vertical position. Fixes on moving the ide back and forth between monitors. Probably related to Federico's bug no. 1.

[HeikoKlare]

Still reproducible on today's master state:

Setup:

• 3 monitors:
  • Left 100% Secondary
  • Middle 175% Secondary
  • Right 100% Primary

Workflow:

• Move application to middle monitor
• Drag a toolbar to a vertical stack (e.g., the left side) so that it shows the preview of inserting it (now it probably looks fine), don't drop it but move it away (now you should see a preview vertical toolbar that is cut off) and the try to drop it at the left side again.

Infos:

• I can only reproduce it in my host SDK, not in a runtime application
• The workflow is non-deterministic, sometimes I face the issue and sometimes I don't
• I would expect this to not occur anymore when we exclude integer200

So in case no one can reproduce this easily, I propose to close this as an integer200-specific issue and see in further testing sessions whether we will face it again. Any objections?

[amartya4256]

I have tried many combinations here and they all seem to work fine. Would someone else also verify please? @akoch-yatta @HeikoKlare @fedejeanne @ShahzaibIbrahim
Things I tried:

• All the reproducers mentioned above both on the current RCP and runtime (I have the latest SWT master)
• Tried primary monitors at 100, 125, 150, 175.

[HeikoKlare]

I cannot reproduce it either and since it seems to have been int200-specific (see #178 (comment)), we may not face it anymore unless we allow int200 scaling for monitor-specific scaling. I have also tested with a defined scale value (-Dswt.autoScale=175) and was also not able to reproduce it.

So, I've just added the according Integer200label and close this as non reproducible with the configurations that we allow.