GTNH-OC-Base-Monitor

Note

Information in this readme was from the original fork, and is inaccurate. README WIP.

Content

• Information
• Installation
• Setup
• Configuration

Information

The program is designed to monitor energy and various materials in AE2 at your base. The program is able to monitor the wireless network in wirelessMode mode. It is also possible to send messages to Discord about out of service situations. And there is also the possibility of auto update at startup.

Thanks to Navatusein for the base code which was expanded upon.

Controls

Q - Closing the program

Arrow Up - Scroll list up

Arrow Down - Scroll list down

Interface

Caution

If you are using 8 java, the installer will not work for you. The only way to install the program is to manually transfer it to your computer. The problem is on the java side.

To install program, you need a computer with:

• Graphics Card (Tier 3): 1
• Central Processing Unit (CPU) (Tier 3): 1
• Memory (Tier 3.5): 2
• Hard Disk Drive (Tier 3) (4MB): 1
• EEPROM (Lua BIOS): 1
• Internet Card: 1

Install the basic Open OS on your computer. Then run the command to start the installer.

pastebin run uuGgDsDy

Or

wget -f https://raw.githubusercontent.com/Navatusein/GTNH-OC-Installer/main/installer.lua && installer

Then select the LSC Control program in the installer. If you wish you can add the program to auto download, for manual start write a command.

main

Note

For convenient configuration you can use the web configurator. GTNH-OC-Web-Configurator

Setup

Note

For easy copying of addresses, use "Analyzer" from the OpenComputers mod. Right-click on the component, its address will be written in the chat. If you click on it, it will be copied.

To build a setup, you will need:

• Adapter: 1

The basic setup is very simple, you just need to connect the LSC with an adapter.