This repository contains everything needed to prepate, analyze, and caluclate PO$_{4}^{3-}$ concentrations for freshwater samples
If only collecting water samples, they should be filtered through a 0.45 micron filter. If the samples cannot be processed the same day, freeze them.
-
Read though the procudure
-
Set up an Excel file to act as a key for the sample locations.
- If not formatted like this key, the code following this will break.
-
After the incubation time is complete, begin to run all samples at 880 nm on the spec
-
Copy the data to a CSV and name it
MMDDYYYY.csv- This is essential to make sure the plate ID matches the corresponding key.
- Open the standard checking and update the relevant information.
- Run the script and examine the
$r^2$ value.- Ideally, all standards produce an
$r^2$ ≥ 0.98.
- Ideally, all standards produce an
- If
$r^2$ is < 0.98, examine the graph and remove problem standards.-
Notes:
- If possible, do not remove a standard that best approximates sample concentration.
- If you have to remove more than 3 standards (only 5 points remaining), something likely went wrong and you should start over.
-
Notes:
- Open the concentration calculation script.
- Update the information to exactly match the settings from above (e.g., plate ID, removed standards).
- Run the script.
- It should output a file with the concentrations of your samples.
- Whenever you want a clean file of your data, run the tidying script.
- Note: Update site names and output paths to reflect your desired output.