KiCad 8.0.4, BOM, and GPIB connector orientation update#66
Open
hharte wants to merge 2 commits intoxyphro:masterfrom
Open
KiCad 8.0.4, BOM, and GPIB connector orientation update#66hharte wants to merge 2 commits intoxyphro:masterfrom
hharte wants to merge 2 commits intoxyphro:masterfrom
Conversation
This file contains hidden or bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
1 participant
Add this suggestion to a batch that can be applied as a single commit.This suggestion is invalid because no changes were made to the code.Suggestions cannot be applied while the pull request is closed.Suggestions cannot be applied while viewing a subset of changes.Only one suggestion per line can be applied in a batch.Add this suggestion to a batch that can be applied as a single commit.Applying suggestions on deleted lines is not supported.You must change the existing code in this line in order to create a valid suggestion.Outdated suggestions cannot be applied.This suggestion has been applied or marked resolved.Suggestions cannot be applied from pending reviews.Suggestions cannot be applied on multi-line comments.Suggestions cannot be applied while the pull request is queued to merge.Suggestion cannot be applied right now. Please check back later.
Hello,
Thank you for developing this project, I have found it very helpful for use with an Agilent 66309D Mobile Communications DC Source.
These two commits are as follows:
First, update to KiCad 8.0.4, update BOM for Digi-Key parts, and add assembly instructions. I had qty 10 assembled by PCBWay.com, and they found during assembly that the GPIB connector Pin 1 orientation was not correct. The second commit fixes the pinout of the connector in the schematic, and pin 1 is correctly oriented in the layout. To be clear, the GPIB connector can simply be installed and works fine with the old PCB layout, it's just that the square hole goes to pin 11 on the connector rather than pin 1.
I haven't fabbed new boards with the second commit.
Take care,
Howard